Lenco Bennett Retrofit Kit - 12V

Product Description

• Use existing Bennett trim planes, lower bracket and switch
  
• Use all existing mounting holes

• 2 electric actuators
  
• 2 upper mounting brackets
  
• Switch wiring kit
  
• All mounting hardware

• Lenco wire feeds through existing oil line hole in transom
  
• Lenco upper mounting bracket fits existing Bennett mounting holes
  
• Existing Bennett trim tab plane and hinge
  
• Existing Bennett lower bracket

• Remove Bennett actuators, and install Lenco upper mounting brackets on transom
  
• Feed Lenco wires through holes in brackets and through existing oil line holes in transom
  
• Mount Lenco actuators on to new upper brackets and existing Bennett lower brackets
  
• Connect Lenco actuator wires to existing harness.

WARNING: This product can expose you to chemicals including di(2-ethylhexyl)phthalate (dehp) which is known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.